Easy way to clean the fan leaves....
You can make a simple equipment from your house hold scraps. I had made one which will dedust the leaves and then wipe the leaves.
Required materials:
PVC pipe pieces.
Same size 2 pvc elbows.
Same size 1 pvc Tee.
bottle cleaning brushes 2 nos.
Some sponge pieces.
Empty water bottle 1 No.
Solvent cement, if necessary.
Take PVC pipe pieces according to the required lengths. Join the pieces as shown in the photo. You may paste it lastly, if required with solvent cement. Make two holes in the left pipe in such a way when the brushes are inserted, these should roll and the nylon bristle should slightly inside the other brush. Two more holes should be made in the right hand side of the pipe. The nylon brushes were inserted parallely in the holes. The sponges are made roller shaped and fixed in the handle portion of the brushes as shown . Tee is to be fixed after positioning the brushes. Then the handle as per the required height. Cut the Water bottle(transparent) lengthwise one side. Fix this bottle over the Tee by pasting or tieing.
Then insert slowly( to avoid dust falling) one of the fan leaves in between the brushes and move which will de-dust that leaf upside and downside. Repeat this action a couple of times. Then remove the equipment from this and insert the another leaf similarly. Repeat the process in the other leaves too. Take out and throw away the collected dust in the cut bottle (dust holder). Then moist the sponges with soap water and insert the leaves one by one between the sponges. Lastly moist the sponge with good water and sweep again.
Leave the round bottom as such because normally dust will not settle in that portion. If necessary, the bottom portion may be rubbed with moist sponge
Fan is fully cleaned off dust.
Do it yourself and use it.
Dastn
Mob 08891442959
You can make a simple equipment from your house hold scraps. I had made one which will dedust the leaves and then wipe the leaves.
Required materials:
PVC pipe pieces.
Same size 2 pvc elbows.
Same size 1 pvc Tee.
bottle cleaning brushes 2 nos.
Some sponge pieces.
Empty water bottle 1 No.
Solvent cement, if necessary.
Take PVC pipe pieces according to the required lengths. Join the pieces as shown in the photo. You may paste it lastly, if required with solvent cement. Make two holes in the left pipe in such a way when the brushes are inserted, these should roll and the nylon bristle should slightly inside the other brush. Two more holes should be made in the right hand side of the pipe. The nylon brushes were inserted parallely in the holes. The sponges are made roller shaped and fixed in the handle portion of the brushes as shown . Tee is to be fixed after positioning the brushes. Then the handle as per the required height. Cut the Water bottle(transparent) lengthwise one side. Fix this bottle over the Tee by pasting or tieing.
Then insert slowly( to avoid dust falling) one of the fan leaves in between the brushes and move which will de-dust that leaf upside and downside. Repeat this action a couple of times. Then remove the equipment from this and insert the another leaf similarly. Repeat the process in the other leaves too. Take out and throw away the collected dust in the cut bottle (dust holder). Then moist the sponges with soap water and insert the leaves one by one between the sponges. Lastly moist the sponge with good water and sweep again.
Leave the round bottom as such because normally dust will not settle in that portion. If necessary, the bottom portion may be rubbed with moist sponge
Fan is fully cleaned off dust.
Do it yourself and use it.
Dastn
Mob 08891442959
No comments:
Post a Comment